My wall controls for my garage door opener won't work!

Question

I just got a new wireless remote control, and when I programmed it, all of the wireless remotes work fine, but for whatever reason, the wall controls in the garage itself will not respond.

I have a Craftsman 315 MHz Garage Door Opener (Model # 139.53910D), and a 3 function handled security garage door opener.

Answer 1

the inside button is hard wired 24 volts low voltage when you were programing the remotes you jarred a wire loose this will be red or white also when this opener was installed, if it was replacing an existing and the wall button switch was not changed this wiil cause probs.

Answer 2

Check the wiring at both the switch and the motor to be sure that they are installed in the correct places and that the wires are secure.  Good luck.

Answer 3

I think that the wires might be twisted or crossed over with the garage door opener, take the opener back with you along with the model number and the receipt with it, and find out why that wall control won't work.ask them how to re fix the control and the wires, and maybe you might just find a miracle that  you might be able to fix that problem.

Answer 4

first check to see if rhere are any breaks in the button wire

next check the button it self with a ohm meter depending on if its a

normally open or closed switch the resistance will change as

you push the button if not the switch is bad

next play with the speed and torque alot of time the safty feature

is a aggitating to get set right to much tor. it will not open

to little it will not close and so forth

take a 2*4 and put it in its path and adjust till the door touches it and raise that will the right adjustment and as long as the wires are right

everthing will work right.

Answer 5

just cut the wires and touch them together the door will open

touch them together again and it will close

if it dont then you have a short change the wire

if it works then

buy any button from radio shack

Answer 6

tap on it with a screwdriver. If that doesnt work, then take it back to the store where you bought it.