Nitro rc car Protech SRT-2?

Question

i havent run it for about a year what should i do run it in again or what please help the more detailed the answer the beter plzzz

Answer 1

http://astore.amazon.com/lego.robotics.k... rc toys and accessories cheap and low price

Answer 2

Take the plug out,put a couple drops of fuel it the cylinder,then remove air filter and shoot a little WD-40 with the throttle wide open,shoot it right down the throat,leave the plug out,close the throttle and turn it over,i assume it's a pull start,pull a few times to loosen it and lubricate it,replace plug and air filter,fuel it up,be sure your glow ignitor has a good charge,put you finger over the exhaust (stinger) and pull it till you see fuel getting close to the carb,the put your ignitor on and fire it up,with both transmitter on and car,check everything,be sure the throttle is working properly,and steering,be sure tires are tight,just inspect it then start it,and make adjustments.