94 dodge 3.3l head torque

Question

94 dodge 3.3l head torque

Answer 1

here should be a site that will tell you what you need to know on that one,good luck,on the left side go to torque sequences and it will tell you what you need to know and how to do it,good luck,  http://www.federal-mogul.com/en/Aftermar...

Answer 2

Install the cylinder head bolts. Tighten bolts Nos. 1 through 8 following the proper sequence as listed below:

Step 1-45 ft. lbs. (61 Nm)

Step 2-65 ft. lbs. (88 Nm)

Step 3- (again) 65 ft. lbs. (88 Nm)

Step 4-additional 1/4-turn

Do not use a torque wrench for Step 4.

Inspect the bolt torque after tightening. The torque should be over 90 ft. lbs. (122 Nm). If not, replace the cylinder head bolt.

Tighten bolt No. 9 to 25 ft. lbs. (33 Nm) only after bolts 1-8 have been tightend to specification.

http://www.autozone.com/shopping/repairG...

Some  internet sites for 3.3L/ 3.8L owners

http://www.allpar.com/mopar/33.html

http://www.automotivetroubleshootingsecr...