Replacing the starter on a 1982 sea ray ?

Question

Just start out in advance thanks for all the great answers I Will be receiving with this post. But a very general question. On a 1982 sea ray inboard 260 merc does the engine need to be pulled in order to replace the starter or can I get out it without doing that. If anyone here has replaced one if you could give me any tips or insight it would be greatly appreciated thanks again guys.

Answer 1

No, you don't have to pull the engine, but as you've probably seen, it's an awkward job.  There are a couple tricks.  A stubby 3/8 drive air- impact makes this much easier. But, if you don't have that, several extensions may let  you work from the front of the engine. and ball swivels really help.  The 2 bolts go in vertically, so the amount of room you have is limited.  Then there's little room to swing the ratchet handle, but it's doable.