Reset pcm 96 3.8 L chrysler town and country?

Question

had bad egr valve transducer. changed out, reset codes now no codes present but sometimes stalls when i slow down and not read status is on egr,02 etc. what procedure should i do to reset readiness status on pcm

Answer 1

Simply disconnect the negative battery cable for a minute or two and reconnect. this will bring the PCM back to factory default and restore the adaptive factors to baseline.

The OBD2 monitors will take a few drive cycles to complete but if not faults are detected they will run and complete.

If the OBD monitors will not complete then you likely still have a problem with something and a code will store.

http://www.epa.gov/oms/epg/keyterm.htm