hello, my kirby shampooer used to work fine, now it does not. i too have had the problem of the suds screen coming loose and lodging in the hose. i took care of that with some glue. for a while, it worked OK. Now when i start to shampoo, for the first few minutes, it works fine and suds are the full width of the tray. after that, it goes into a little line about 4 inches wide unless i pull back super slowly. even then sometimes it will put out very little suds or none at all. what else can cause that? the switch fully opens in the ON position, the sud screen is present and not clogged, the hose is not clogged, everything is clean and assembled properly, and i use the correct amount of kirby shampoo. any help would be greatly appreciated. thanks!
Tags: