So How do u put traction pads and where u put it ?

Question

So How do u put traction pads and where u put it ?

Answer 1

on what i need more info very vague question

Answer 2

if you have a used board, first you have to scrape off all of the wax near the tail and clean it with something like nail polish remover. then you make sure there is nothing on the area where you are going to place the pad (extra wax, dust, stuff like that). then usually put the pad on the board and trace where you want to put it with a pensil. when you have it where you want it, take off the back and carefully place the pad on the board right where you traced it. the pad usually goes near the tail of the board with enough room for the leash plug (1,2,3 inches) i hope this helps!

Answer 3

No disrespect intended, but Acetone/nail polish remover will eat the board. Use plain rubbing alcohol to clean the tail of the board.  You should get instructions and an alcohol/solvent wipe included with the traction pad.