Some assembly tips or some help PLEASE?!?

Question

I bought a desk that you have to assemble and I cant get the f'in screws in there. They are the thread screws and manual says to apply some pressure and force and I do and the b******s dont s***w in all the way!!! It's pissing me off. Has anyone had this problem or a solution or any tips? Also when you put the screws into the wood parts, they also refuse to go all the way in. UGH!!! Any help please. Thanks.

Answer 1

Take a small nail or pin and make sure the pilot holes are drilled deep enough.  You can also put a drop of liquid soap on the s***w before inserting to help it go in easier.

Answer 2

Normally when you assemble one of the kits, there is a small pilot hole already started in both pieces to make it easy. Make sure you have the right pieces in place.

If you do you may want to use a cordless screwdriver or a cordless drill with a screwdriver bit. This is much easier than trying to do it by hand.

Answer 3

Can't tell what the problem is.  Send me a picture.