Urgent computer problem?

Question

my computer finally turned on and the problem is/was that the monitors

led light i think didnt turn blue like its supposed to but it made all the usual noises and my screen would just say gateway or say no signal and then turn off i know i cant explain it well but if anyone knows anything about this plz answer thx

Answer 1

Check your video card or i think it is your settings it to high for the monitor lowe the down the pixels settings.If you monitor is dead there would not be anything at all so it is your settings i think.

Answer 2

Maybe update the monitors drivers.  Make sure (I know this is obvious) the monitor is plugged into the ac and whatever else it needs to be, like a USB or parrallel.

Answer 3

If it says you have "no signal" there is no reason to start messing with "drivers" or software since there is clearly a hardware problem. Deal with that first.

First check the cable that connects your computer to the Monitor. It may have come a bit loose. If it's possible to do so,  make the connection more secure. Check that the cable has not been damaged or bent too sharply as this can make it fail to work properly.

If you have both on-board video and a separate video adapter card installed you may have attached the cable to the monitor to the wrong video signal output port.

If you think that the video adapter card is not working properly you can check it by replacing it with a known good video adapter card.

If you still have "no signal" with a known good video card you have a faulty cable.

If you do not have a video card to use to check this - you can try a new display cable.

Answer 4

I would suggest that you check to be sure that everything is connected and that the cord didn't fall out or there aren't any bad connections.

If everything's connected properly, then I would suggest that you try making sure that your video card is working.

Good luck and I hope I helped you!