Question:

VIOLIN how do you play it?

by  |  earlier

0 LIKES UnLike

You strum guitar, so what do you do with violin? what is that hand gesture called when you play the violin?

 Tags:

   Report

2 ANSWERS


  1. i wish i knew. but i dont


  2. Playing the Violin

    The standard way of holding the violin is with the left side of the jaw resting on the chinrest of the violin, and supported by the left shoulder, often assisted by a shoulder rest. This practice varies in some cultures; for instance, Indian (Carnatic and Hindustani) violinists play seated on the floor and rest the scroll of the instrument on the side of their foot. The strings may be sounded by drawing the hair of the bow across them (arco) or by plucking them (pizzicato). The left hand regulates the sounding length of the string by stopping it against the fingerboard with the fingertips, producing different pitches.

    Left hand and pitch production

    As the violin has no frets to stop the strings, the player must know exactly where to place the fingers on the strings to play with good intonation. Through practice and ear training, the violinist's left hand finds the notes intuitively by muscle memory. Beginners sometimes rely on tapes placed on the fingerboard for proper left hand finger placement, but usually abandon the tapes quickly as they advance. Another commonly-used marking technique uses dots of white-out on the fingerboard, which wear off in a few weeks of regular practice. This practice, unfortunately, is used sometimes in lieu of adequate ear-training, guiding the placement of fingers by eye and not by ear. Especially in the early stages of learning to play, the so-called "ringing tones" are useful. There are nine such notes in first position, where a stopped note sounds a unison or octave with another (open) string, causing it to vibrate sympathetically.The fingers are conventionally numbered 1 (index) through 4 (little finger). Especially in instructional editions of violin music, numbers over the notes may indicate which finger to use, with "0" indicating "open" string. The chart to the left shows the arrangement of notes reachable in first position. Not shown on this chart is the way the spacing between note positions becomes closer as the fingers move up (in pitch) from the nut. The bars at the sides of the chart represent three of the usual tape placements for beginners, at 1st, high 2nd, and 3rd fingers.

    Positions Playing Violin

    The placement of the left hand on the fingerboard is characterized by "positions". First position, where most beginners start (although some methods start in third position), is the most commonly used position in string music. The lowest note available in this position in standard tuning is an open G; the highest note in first position is played with the fourth finger on the E-string, sounding a B, or reaching up a half step (also known as the "extended fourth finger") to the C two octaves above middle C.Moving the hand up the neck, so the first finger takes the place of the second finger, brings the player into second position. Letting the first finger take the first-position place of the third finger brings the player to third position, and so on. The upper limit of the violin's range is largely determined by the skill of the player, who may easily play more than two octaves on a single string, and four octaves on the instrument as a whole, although when a violinist has progressed to the point of being able to use the entire range of the instrument, references to particular positions become less common. Position names are mostly used for the lower positions and in method books; for this reason, it is uncommon to hear references to anything higher than fifth position. The lowest position on a violin is half-position, where the first finger is a half-step away from the nut. This position is less frequently used. The highest position, practically speaking, is 15th position.The same note will sound substantially different, depending on what string is used to play it. Sometimes the composer or arranger will specify the string to be used in order to achieve the desired tone quality; this is indicated in the music by the marking, for example, sul G, meaning to play on the G string. For example, playing very high up on the lower strings gives a distinctive quality to the sound. Otherwise, moving into different positions is usually done for ease of playing.

Question Stats

Latest activity: earlier.
This question has 2 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.