i have this iwata is-925 air brush gun ,the water separator does not seem to be doing its job ,i am getting water come through the gun,when using the gun and looking at the water trap site glass the water seems to be splashed up against the glass,when i push the water release not much water comes out ie more water comes out of the gun than that what should be caught in the trap,looking at the lay out on the regulator there are 4 holes one is the air inlet which is what it is but for the hole marked out it is bunged off with a cap on the left and right which has no marking the pressure gauge is attached which operates fine on the oppisite side is the hose that goes to the gun is this the problem that i am having is this hose ment to be connected to the hole marked out one woul think so ,or does it not matter can either 3 holes be used and the water separator work on all of them ,hope you can under stand my english be good to here from you
Tags: