Question:

Wats the diffrence between amd ,celron and pentium processor?

by  |  earlier

0 LIKES UnLike

i know there is speed difference bt how???

 Tags:

   Report

3 ANSWERS


  1. i think that the pentium processor is a good amount faster than celron because pentium has a wide selection of speeds and processors between pentium 1,2,3,4, duo-core, and quad-core


  2. the main differences between Celerons and Pentiums are in the areas of bus speed and L2 cache features. Both Pentium-II's and -III's ship with 512kB of secondary (L2) CPU instruction cache. This allows the CPU to store recently used instructions close by and is responsible for much of their high performance.

    The Celerons that Intel first introduced as a low-cost CPU alternative (266 & 300MHz versions) were basically just Pentium-II's without any L2 cache at all. This deficiency really punished Celeron performance when compared to competitive AMD and Cyrix chips. In response, subsequent Celeron versions (300A and up) were provided with 128kB of L2 cache. Though only one-quarter the size of the Pentium cache, it was built to run at the full speed of the respective CPU, rather than at half-speed as in the Pentiums. Due to its higher manufacturing cost and technical issues, the larger Pentium cache memory has always been set to run at only half the speed of the CPU itself. For a full-speed L2 in a Pentium design, you need to get into Intel's (much more expensive) Xeon line.

    What Intel plays down-- but nearly everyone knows-- is that the full-speed, quarter-size Celeron cache gives them almost the same performance as the half-speed, full-size cache gives Pentiums. Thus you'll find that, for most applications, Celerons rated at the same MHz will equal or better an equivalent Pentium-II, for a much lower price.

    For example:

         Celeron @ 466MHz x 128kB L2 @ 466MHz =>

         Pentium-II @ 450MHz x 512kB L2 @ 225MHz

    Pentium-III's are given an added boost with an inherently faster system bus speed (100MHz vs. 66MHz for the Celerons) and Intel's new SSE 3D instruction set. This combination of hardware and firmware enhancements gives Pentium-III's a significant edge over the Celeron's smaller cache and slower bus.

  3. well when the silicon is cut for the processors it is one big sheet and the most pure is in the center which is the highest quality and the out is the lower quality. well that outside silicon is used for the celron chips which is why they are cheaper. there is nothing wrong with it its just not good enough quality for the high performance chips

Question Stats

Latest activity: earlier.
This question has 3 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.