Question:

What are the directions for boiling Shock doctor Power Gel Ultra?

by  |  earlier

0 LIKES UnLike

I got it and i put it in boiling water and took it our with chopsticks and some of it melted away into the chopstick and some of the gel is loose so help what should i do now

 Tags:

   Report

1 ANSWERS


  1. Power Gel Ultra fitting instructions:

    1. Fill saucepan with 3 to 4 inches of water.

    Bring water to a boil.

    2. Remove water from heat source. Immediately

    place mouthguard (tongue tag down) in water for

    90 seconds. Do not remove before 90 seconds.

    3. Carefully remove mouthguard from hot water

    with a slotted spoon.

    4. Cool mouthguard under tap water for 1-2

    seconds only to bring surface temperature to a

    comfortable level. l**k your lips before placing

    mouthguard in your mouth.

    5. Watching in mirror, line up mouthguard carefully

    with the centerline of upper teeth – use tongue

    tag to center mouthguard. Fit mouthguard onto

    and around upper teeth (tongue tag upward) and

    press firmly into molars first then front teeth.

    6. Bring lower jaw forward and up into base of

    mouthguard with teeth in alignment with lower

    channel.

    7. Put tip of tongue on tongue tag end and close

    mouth while biting down hard on mouthguard.

    Suck in strongly and use fingers to press edges of

    mouthguard into teeth and gum line through lips

    and cheeks for 20 seconds.

    8. Remove mouthguard and cool under tap water for

    30 seconds. Replace into mouth and test for

    a good, firm fit.

    9. Repeat steps 1 through 8 if fit is not accurate.

Question Stats

Latest activity: earlier.
This question has 1 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.