What can i do to make my protection led go away and mt green power light to come on?

Question

i have a pyle 1800 watt amp and i have everything hooked up right but when i turn on my car the light is either red or blank

my capacitor is plugged in and working but the amp is not

Answer 1

your subs are wired up wrong, try wireing them in a series, this will up the ohm load and take your amp out of protection. it goes into protection because your ohm load is to low. or get a new amp because that amp is cr.ap

Answer 2

i dont think ur subs are hooked up wrong but plz check make sure ur ground wire is tight i had an amp that did the same thing found a new ground and was back in business  good luck to u