What is the best HC amp to push #3 3000watts pionner subwoofers ? & what u think about MA audio or us amp?

Question

ok can someone tell me what is the best amp to push #3 3000watt pionner subs

Answer 1

you need to stick with companies that are CEA-compliant which means that they produce or exceed the advertised RMS wattage with minimum distortion

both of those brands are highly over rated, you would be lucky to get half of the advertised RMS wattage from them

CEA-2006 Compliant

On May 28, 2003, the Consumer Electronics Association published standard CEA-2006, "Testing & Measurement Methods for Mobile Audio Amplifiers." This "voluntary" standard advocates a uniform method for determining an amplifier's RMS power and signal-to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz. Signal-to-Noise ratio is measured in weighted absolute decibels (dBA) at a reference of 1 watt into 4 ohms. This applies to both external amplifiers and the amplifiers within in-dash receivers.

CEA-2006 allows consumers to be able to compare car amplifiers and receivers on an equal basis. Manufacturers who choose to abide by the new standard are able to stamp their products with the CEA-2006 logo that reads: "Amp Power Standard CEA-2006 Compliant."

here are the top CEA-compliant brands

Alpine  

Bazooka  

Blaupunkt  

Clarion  

Eclipse  

Infinity  

JBL

JL Audio  

Kenwood

Kicker  

MTX  

Pioneer

Polk Audio

Rockford Fosgate  

Sony

Answer 2

1st of all, in my experience I have seen that the best amps out there are US AMPS. If you could afford it, Go with US AMPS. Memphis Audio Does not even come close to Quality And clarity that you will get out of US. Compare prices and remember, you get what you pay for. If you want raw unadulterated power look into ZAPCO amps. For pure DB's They will Pound and make your heart skip a beat!!!Zapco and US AMPS have been known as cheater amps, They label their Amps at 500 rms @8 ohm but will push around 1800 rms @ 1 ohm and are stable at 1 ohm. Most CEA compliant Amps will be stable only at 2 ohm for mono amps.