Question:

Where can I find a wiring diagram to install a fuel gauge on a 93 sea rayder?

by  |  earlier

0 LIKES UnLike

Any help will be appreciate. There is a lot of wires under the dash. I replaced the old gauge on dash and teh sender (I think thats the name) on the gas tank, still not working. THanks

 Tags:

   Report

3 ANSWERS


  1. i dont have a diagram--sorry. But remember that its not like a car. there has to be a hot wire and a nuetral wire for anything to work.  A wire from both the + and the -  sides of the battery.


  2. if you go to the library they have a website you can go to called "Alldata.com" you cant look at it from your computer cause you need to pay for it but the library's have it.

  3. There are 4 wires> red or purple power from switch> Black or yellow ground> Has to be on the tank next to the sending unit> The center wire on the sender goes to the S sender on the guage> blue is for the light>G ground> To test the sender take the wire off the sender> with key switch on & power to the guage> Touch the sender to the ground only touch> The guage should go to full>If does than the wire & guage is working>If not Check the wire & guage>If so than take sender out and make sure you put it in correctly and it's not touching the side and will float up and down>This should help you>

Question Stats

Latest activity: earlier.
This question has 3 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.