Where can i find out how to adjust the governer on a golf cart?

Question

cant stand going slow

Answer 1

Determine the type of governor your golf cart has. The most common are spring loaded, a clutch and throttle combination and finally a spark regulator.

Locate the spring assembly along the carts acceleration system. You'll find the spring located on the carburetor or the differential. Adjusting the tension on the spring will raise and lower the golf carts speed.

Lengthen the cable attached to the throttle body on a clutch and throttle two-stroke engine. The cable attaches to a lever on the carburetor. Loosen the cable nut and extend the length of cable until the governor is no longer activated when pressing the gas peddle.

Bypass the spark regulator on an electronically controlled governor. Remove the wires from the governor and splice the ends together carefully and wrap the splice in electrical tape using a weatherproof joiner or twist connector. This method only works if the governor is separate from the ignition system. If your cart has a one piece ignition governor you'll have to replace it with a single ignition switch.