Where can i purchase a virtical bandsaw to cut foam?

Question

i prefer used, do to high cost. it dose not have to be fanncy.

table should be able to move back and forth no programing.

table needs to be at least 60" long, longer better.

Answer 1

I have seen people cut foam with "hotwire" which is a bare wire connected to two handle with an on-off trigger on one end and plug into a low voltage transformer. It will require 2 people to operate this. The 2 will hold the handle tight, so that the wire is straight, then the guy with trigger will pull and hold it down, the wire will be then red firely hot, the 2 will then move the "hotwire" up and down back and forth a couple of times then exit the foam. The foam will have a nice and clean cut. This can handle virtually no limited to the thickness or the width or lenght of the foam.