Question:

Where do you spray carb cleaner into a 50 hp evinrude?

by  |  earlier

0 LIKES UnLike

i know its in the carb but where the heck is the inlet?

 Tags:

   Report

8 ANSWERS


  1. Move the linkage and watch for the baffels to move, spray it right in there.


  2. youll see 2 cylinders that formed from 1. from those 2 cylinders will be your carbs. when you hit your gas u will see that the throttle botties open up. spray in there when you have the gas down. then let it run

  3. you don't.

    carb cleaner has no lubricating qualities, but it is an excellent solvent.

    it will clean the lubricating oil right off the cylinder walls.

    if you wouldn't run your engine without oil, don't run it on carb cleaner.

    Only one way to properly clean a carburetor.  Remove, disassemble, soak overnight in carb cleaner, blow through all passages with compressed air (or aerosol carb cleaner), reassemble with new kits.

  4. http://www.sterndrive.info/outboardmotor...

    Hope this helps...

  5. right in the carb itself

  6. yes

  7. Remove fuel line where it goes into carb, then spray cleaner into the hole until it flows back out. Remove spark plugs and turn motor over a couple of times with the throttle wide open. Spray again into hole where fuel line came off until it flows back out. It is very important that you leave the motor sit for 24 hours. After that put fuel line back on and plugs back in. Change the fuel filter and check there are no leaks in the gas line. The motor should start within three cranks.

  8. please have someone help you with this if you do not know how

Question Stats

Latest activity: earlier.
This question has 8 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.