Who can tell me the maintenance of ball mill?

Question

my friend bought a ball mill last year ,but he do not know how to maintain it ,either i am not so clearly now ,who can help me ?

Answer 1

ok ,i give you some suggestions

1.The bearing on the processing of the base is in the same horizontal surface, the center spacing tolerances 1 mm, not parallel longitudinal centerline of deviation 0.5 mm, and horizontal deviation of the centerline of 0.5 mm per metre .

2.Watts Block spherical contact angle should to be uniform for each 50 ⅹ not less than 50 mm2, 1-2; hollow shaft contacting  with the Vanuatu should be 90 ° -100 ° every square inch should be  no less than 2:00, the Journal and bearing clearance on both sides should approximate the same.

3.Ball Mill with the front flange cylinder cover should ensure that the co-ordination of good contacts, and no pads, two different hollow shaft axis of less than 0.8 mm tolerance, when the ring gear in connection with the cylinder assembly correction, the thrust should be solid, Hong positioning pin, the radial Gear swing of not more than 0.5 mm axial swing of not more than 0.84 mm.

  if you want amore edetails ,please go to http://www.chinapulverizer.com

http://liming.sulekhab2b.com