Would it be ok for me to hook up .67 ohm's to a 1ohm stable amp or do i need a .5 ohm amp!!! this is car audio

Question

i got 3 memphis dual 4 ohm subs and i want to hook them up to my 1 ohm stable memphis amp at .67 ohms so it will be louder! its hooked up at 2.67ohms now and its not loud enough! would it be safe to run at .67 ohms on this 1 ohm amp? help me

Answer 1

why not just drop one of the subs and run at 1 ohm the only difference is  +/- 3 dbs???

Answer 2

First of all .67 is one ohm so it is one ohm stable if you measure a 4 ohm voice coil it wont measure 4 ohms because the voice coil is not in motion so whenever you measure a speakers load the load will always read less. IF YOUR READING WAS LESS THEN 0.5 OHM'S THEN YOU WOULD NEED AN AMP THAT IS A HALF OHM STABLE       YES IT WOULD BE SAFE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!...

Answer 3

I would say either go with the first guys advice use 2 and run them at 1 ohm. Or you could design an amp rack, put 12v fans on it to help keep it cool and don't over do it with you gain or theres a good chance you will fry it. If you get the fans and don't over do it though like I said you should be fine if you want to run all 3.