[dumb question] is it possible to bolt up a 250cc carb to a 50cc motor?

Question

i got a little 49cc go ped and i was wondering if i could rip the old carb off my 250cc dirtbike... there both two strokes

extreme scooters 49cc goped

1974 suzuki tc or a ts dirtbike

Answer 1

Sure, anything's possible.  But I wouldn't if I were you.

Answer 2

No

Answer 3

ive seen a busa engine (1300cc) in a go cart. lol so its possible

Answer 4

there ARE NO  dumb questions,only dumb answers,like this one

Answer 5

I would think that the two are different sizes and will not seal properly against the air intake and engine. Also, the amount of air allowed to flow by your 250 cc carb would probably be too great for the little scooter.

Hey, the worst that can happen is that you'll have to put the carb back on the 250.

good luck.....

Answer 6

All engines, two stroke, four stroke, gas turbine, diesel, etc. can only flow a certain amount of air at a given rpm and state of tune or modification.

So, a 3 cu. in. engine trying to draw thru a carb for a 15.25 cu. in. engine ... at one third throttle you would be wound out, IF:

you could make or find the adaptor needed to mount the carb.

My suggestion: don't try any carb more than 10% larger than stock on a stock engine.

Budd

Answer 7

No,the 50cc will not create enough pressure in the carb to draw any fuel.