I have a monophonic push-pull 6V6GT amplifier/preamplifier chasis from the mid 50's that needs some new electrolytics to replace the originals. I've bought caps with acceptable values, but I'm not sure how to install them. There's the stock four-section filter can, which has four tube socket-like leads coming out the bottom. Each of these leads corresponds to a symbol of some sort (square, semi-circle, or triangle,) I think telling me which lead corresponds to which cap in the can. I do believe the set grounds to the filter cap, but beyond that I'm not sure. Point is, I just can't figure out the symbols nor the circuit- my filter cap circuitry looks to be more complex than anything I've seen on the Web! I just need to know roughly how to wire in the new caps below, obeying polarity in building a new pack.
Perhaps there's somebody like a guitar amp tech or radio restorer who can look at my picture and help figure this out. I've included a photo of both my chasis and filter cap. Basically, I'm looking for a more personal bit of help in how to do this to clear up what Web guides don't. I've already soldered in new Mallory polys to replace the paper CDEs, but this just escapes me. I know it's a lot of work to look at my circuit and explain, but it might get me really into the hobby :D
(Chassis top)
http://www.imagecross.com/06/image-hosting-view-04.php?id=3711100B2890.JPG
(Filter can engravings)
http://www.imagecross.com/06/image-hosting-view-04.php?id=8843100_3144.JPG
(filter can wiring- Can values go 40-40-40-50, in that order.)
http://www.imagecross.com/06/image-hosting-view-04.php?id=8095100_3152.JPG
And yes; the amp runs AS-IS with some buzzing and hum, and yes, my multimeter says the caps have no DC voltage on them. There's no schematics available, but if you need it, I can take a shot of the full under-chasiss.
Lastly, I'd like to thank in advance anyone nice enough to reply. If you know a better place to ask this, or just have general advice on how to do this, I'd also appreciate it.
Tags: